Debugger issue

[quote='[DH]' pid='193889' dateline='1378670700']
thanks, this issue will be fixed in next revision

Every time I try to do a step by step debug and I get to an sc call I get this error

Code:

[E : DisAsmFrame Thread]: GetCurrentPPUThread: bad thread

Why does it do that? can it be fixed?

so, I checked into it a little bit and I see that when the interpreter is executing a syscall it tries to get the current thread, but when I do it with the step button it get the thread of the disassembler and it sees that its not a ppu thread so it throws the exception.
if there is a better way to get the current ppu thread it should be used

well that's because the syscalls start from 1 and not from 0
what did you try to run? is it one of the elfs from the repository or did you compile something yourself?