Less than 1 minute ago
elisha464
09-06-2013, 07:53 PM
Every time I try to do a step by step debug and I get to an sc call I get this error
Why does it do that? can it be fixed?
Code:
[E : DisAsmFrame Thread]: GetCurrentPPUThread: bad thread
Why does it do that? can it be fixed?
elisha464
09-07-2013, 08:11 AM
so, I checked into it a little bit and I see that when the interpreter is executing a syscall it tries to get the current thread, but when I do it with the step button it get the thread of the disassembler and it sees that its not a ppu thread so it throws the exception.
if there is a better way to get the current ppu thread it should be used
if there is a better way to get the current ppu thread it should be used
elisha464
09-07-2013, 07:10 PM
well that's because the syscalls start from 1 and not from 0
what did you try to run? is it one of the elfs from the repository or did you compile something yourself?
what did you try to run? is it one of the elfs from the repository or did you compile something yourself?