Black Screen Problem
Started by GeorgeM




1 posts in this topic
GeorgeM
Member


0
1 posts 1 threads Joined: Nov 2019
Exclamation  11-25-2019, 08:43 AM -
#1
So I'm new to all of this but I believe I have a relatively good understanding of how it all works. I have installed RPCS3 all fine and then went to boot Lego Batman 2. It seemed to work fine until the game actually launched - at which point all that was displayed is a black screen. I have left all of the configurations at default/global AND I have messed around with the resolution, etc to see if that helps. No luck. My system is a Lenovo ThinkPad T440 with an i5, and Intel's iGPU (yes, I know it's not going to run the emulator very well but I wanted to give a few games a try anyway). Could anybody give me a few pointers? Thank you.

Just ask if you need a log file or anything, I wasn't sure which one to attach.
Ani
Administrator
*******


16
4,264 posts 105 threads Joined: Aug 2017
11-26-2019, 03:27 PM -
#2
Intel iGPUs are not supported because drivers are very bad, specially on 4th gen. Check if your card actually supports OpenGL 4.3 as indicated on minimal requirements.
If you're already sure it does, follow the support guidelines and attach the compressed RPCS3.log file.
This post was last modified: 11-26-2019, 03:28 PM by Ani.
    Desktop: Ryzen 7 5800X,   Radeon RX 6800 XT, 2x8G DDR4 3600MHz, Manjaro Linux
     Laptop: Ryzen 9 5900HX,  Radeon RX 6700M,   2x8G DDR4 3200MHz, Manjaro Linux
Old Desktop: AMD FX-8350,     Radeon R9 280X,    2x4G DDR3 1600MHz, Manjaro Linux


Forum Jump:


Users browsing this thread: 1 Guest(s)