rpcs3 needs save and load features
Started by zxaxz




4 posts in this topic
zxaxz
Member


0
5 posts 2 threads Joined: Dec 2019
12-20-2019, 03:12 PM -
#1
I hope to add save and load to emulator this will help us playing games that are not working properly (in game) .For example i played red dead redemption and i was about to finish some mission but emulator stop working at some point in that case i've to start over that mission but if there is save and load then i can continue from the last point i was reach .
Ani
Administrator
*******


16
4,373 posts 105 threads Joined: Aug 2017
12-20-2019, 06:18 PM -
#2
You can save and load through the game's mechanisms for that effect.

If you're looking to implement save states, it's not feasible if possible at this point.
    Desktop: Ryzen 7 5800X,   Radeon RX 6800 XT, 2x8G DDR4 3600MHz, Manjaro Linux
     Laptop: Ryzen 9 5900HX,  Radeon RX 6700M,   2x8G DDR4 3200MHz, Manjaro Linux
Old Desktop: AMD FX-8350,     Radeon R9 280X,    2x4G DDR3 1600MHz, Manjaro Linux
zxaxz
Member


0
5 posts 2 threads Joined: Dec 2019
12-21-2019, 09:44 AM -
#3
(12-20-2019, 06:18 PM)Ani Wrote: You can save and load through the game's mechanisms for that effect.

If you're looking to implement save states, it's not feasible if possible at this point.
The problem is that red dead redemption saves after finishing missions and emulator stops working and crashes just before the end of mission or during missions .
Ani
Administrator
*******


16
4,373 posts 105 threads Joined: Aug 2017
12-21-2019, 04:59 PM -
#4
It's not Playable, so crashes are to be expected

Even if you managed to save the whole emulator state and resumed it afterwards it would very likely crash the same way since it's resuming the same state
    Desktop: Ryzen 7 5800X,   Radeon RX 6800 XT, 2x8G DDR4 3600MHz, Manjaro Linux
     Laptop: Ryzen 9 5900HX,  Radeon RX 6700M,   2x8G DDR4 3200MHz, Manjaro Linux
Old Desktop: AMD FX-8350,     Radeon R9 280X,    2x4G DDR3 1600MHz, Manjaro Linux
zxaxz
Member


0
5 posts 2 threads Joined: Dec 2019
12-24-2019, 12:04 PM -
#5
Thanks for reply


Forum Jump:


Users browsing this thread: 1 Guest(s)