01-02-2021, 08:18 PM -
RPCS3 v0.0.14-11581-c06707c8 Alpha | HEAD | Firmware version: 4.87
Version 01.00
Vulkan:
Tested with default settings and SPU loop detection disabled.
Game boots and goes ingame. In race the game stays above 30FPS but with massive blinking. Replay mode goes below 30FPS. Runs at 60FPS in menu and race selection screens. Emulator crashes while closing the game. This will only work (at least for me) the first time you boot the game from a clean start. Once you boot it a second time, the game will crash and wont allow you to play it anymore.
Log file: RPCS3.log.rar
RPCS3 v0.0.14-11584-a2e8e309 Alpha | HEAD | Firmware version: 4.87
OpenGL:
Tested with default settings, SPU loop detection disabled and:
- PPU Decoder Interpreter (fast).
- SPU Decoder Recompiler (ASMJIT).
- Lower SPU thread priority enabled (You may wanna keep this uncheck).
Game boots and goes ingame but it's barely playable. The game runs at 10-15FPS in race, has massive blinking and it's very buggy. Menu and race select screens will run at 60FPS. This settings wont crash the emulator and will be able to boot it a second time and played it without crashes or errors.
Log file: RPCS3.log.gz
Version 01.00
Vulkan:
Tested with default settings and SPU loop detection disabled.
Game boots and goes ingame. In race the game stays above 30FPS but with massive blinking. Replay mode goes below 30FPS. Runs at 60FPS in menu and race selection screens. Emulator crashes while closing the game. This will only work (at least for me) the first time you boot the game from a clean start. Once you boot it a second time, the game will crash and wont allow you to play it anymore.
Log file: RPCS3.log.rar
RPCS3 v0.0.14-11584-a2e8e309 Alpha | HEAD | Firmware version: 4.87
OpenGL:
Tested with default settings, SPU loop detection disabled and:
- PPU Decoder Interpreter (fast).
- SPU Decoder Recompiler (ASMJIT).
- Lower SPU thread priority enabled (You may wanna keep this uncheck).
Game boots and goes ingame but it's barely playable. The game runs at 10-15FPS in race, has massive blinking and it's very buggy. Menu and race select screens will run at 60FPS. This settings wont crash the emulator and will be able to boot it a second time and played it without crashes or errors.
Log file: RPCS3.log.gz
This post was last modified: 01-17-2021, 06:43 PM by raidenninjamgs4.