07-01-2020, 11:43 PM -
Hi all
I'm new to RPCS3. I've followed the Quickstart guide and am trying to follow the recommended method in the Controller Configuration page on the Wiki to connect my Dualshock 3 controller.
I've installed the DualShock 3 drivers v3.0.0.0, restarted my PC, then connected the controller and pressed the PS button in the middle of the pad, as per the wiki. When I open RPCS3 and go to Gamepad Settings, I can see that the controller is detected using the dedicated DualShock 3 pad handler. However, it doesn't seem to register any button presses or analog stick movements.
I've attached my compressed RPCS3.log file, which seems to show the left stick is being pressed down constantly (if I'm reading it right). But I'm not pressing anything on the controller so this doesn't make sense to me.
Any ideas?
I'm new to RPCS3. I've followed the Quickstart guide and am trying to follow the recommended method in the Controller Configuration page on the Wiki to connect my Dualshock 3 controller.
I've installed the DualShock 3 drivers v3.0.0.0, restarted my PC, then connected the controller and pressed the PS button in the middle of the pad, as per the wiki. When I open RPCS3 and go to Gamepad Settings, I can see that the controller is detected using the dedicated DualShock 3 pad handler. However, it doesn't seem to register any button presses or analog stick movements.
I've attached my compressed RPCS3.log file, which seems to show the left stick is being pressed down constantly (if I'm reading it right). But I'm not pressing anything on the controller so this doesn't make sense to me.
Any ideas?