+- RPCS3 Forums (https://forums.rpcs3.net)
+-- Forum: Support & Issues (https://forums.rpcs3.net/forumdisplay.php?fid=17)
+--- Forum: Support (https://forums.rpcs3.net/forumdisplay.php?fid=18)
+--- Thread: Logitech Rumblepad 2 (/showthread.php?tid=205224)
Logitech Rumblepad 2 - ziobyte - 12-14-2022
Hi,
I'm very new to RPCS3 so I may be missing something far too obvious,
Please be lenient
I just installed RPCS3 and connected my old Logitech RumblePad 2 controller which seems to be recognized.
This is the default configuration:
(I seem unable to upload an image)
in this configuration right joystick (apparently mapped to "Trigger Thresholds") seems to work ok, but "Analog Stick Deadzones" (left) is severely off-center and (right is centered, but doesn't move at all).
OTOH if I edit ~/.config/rpcs3/evdev_positive_axis.yml putting "true" in the first 6 settings (as advised in wiki) "Analog Stick Deadzones" (left) seems ok, but right joystick (all the same mapped to "Trigger Thresholds") is off-center (neutral position on joystick is flushed left on screen); right joystick does not seem to map to right deadzones at all.
Can someone point me to docs about how to setup my controller?
I was not able to understand how to test it (I *was* able to change settings, more or less, but not to verify everything works as expected).
I aam most evidently missing something :/
Thanks in Advance
ZioByte