Complete system freeze after updating to 0.0.6 - Printable Version +- RPCS3 Forums (https://forums.rpcs3.net) +-- Forum: Support & Issues (https://forums.rpcs3.net/forumdisplay.php?fid=17) +--- Forum: Support (https://forums.rpcs3.net/forumdisplay.php?fid=18) +--- Thread: Complete system freeze after updating to 0.0.6 (/showthread.php?tid=200739) |
Complete system freeze after updating to 0.0.6 - LewisDTC - 08-14-2019 It was a few years ago that I last used RPCS3, but recently I decided to run through Persona 5 again. I already had v0.0.2 installed, but figured that updating the emulator would probably fix a few graphical glitches and improve performance. I downloaded 0.0.6 and attempted to install the firmware: however this caused a full system crash: froze up completely followed by a BSOD. Tried an older firmware version and got very much the same thing. Figuring I already had the old version with the firmware installed, I tried copying the files over my existing install. This worked and I could access the emulator and see that the new version was running, however now when I try to launch the game it gets as far as "Compiling PPU module 0 of 61" before again, freezing completely and bluescreening. I've tried running as an Administrator, messing with the compatibility settings and playing with the process priority in task manager to no avail. I managed to switch my renderer from Vulkan after reading that some people had issues with that, but nothing. My system is certainly capable of running the software (I7-4790K, GTX970, 8G Ram) and the only physical change since the last time I played is that I had to replace a blown power supply. My drivers are up to date. As a side note: my system froze entirely while in the configuration screen at one stage - not even attempting to run a game. So I'll be perfectly honest: I'm out of ideas here. Any thoughts, oh smart people of the internet? RE: Complete system freeze after updating to 0.0.6 - Ani - 08-15-2019 Log is corrupt, no idea what's going on there, seems like your system has some stability issues RE: Complete system freeze after updating to 0.0.6 - Virinom - 08-15-2019 It might be because of unstable overclock. RE: Complete system freeze after updating to 0.0.6 - LewisDTC - 08-16-2019 I mean it's certainly possible but it's been perfectly stable for the past six years or so, and RPCS3 is the only thing that has caused anything remotely like this. Tried a few more times: same results. Sometimes it shows more or less PPU modules to compile, but it's consistently 0/XX that it crashes on. One of life's mysteries I suppose. Thanks for taking a look at the logs regardless. |