+- RPCS3 Forums (https://forums.rpcs3.net)
+-- Forum: PS3 Commercial Games (https://forums.rpcs3.net/forumdisplay.php?fid=4)
+--- Forum: Intro (https://forums.rpcs3.net/forumdisplay.php?fid=7)
+--- Thread: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] (/showthread.php?tid=200673)
Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - GrantKane - 07-20-2019
RPCS3 v0.0.6-8400-9a7c2784 Alpha | HEAD | Firmware version: 4.84
The game freezes after intro logos.
![[Image: ZAolnQF.png]](https://i.imgur.com/ZAolnQF.png)
RE: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - Darkhost1999 - 01-28-2024
This game has a workaround for those looking to play.
The workaround is to use default settings at the time of writing + vblank rate 1800hz.
But the status due to this disqualified setting is Intro only.
I hope this workaround helps someone else until the problem is resolved.
RE: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - 1qazxcvbnmlp098 - 05-01-2024
RPCS3 v0.0.31-16394-55fccf03 Alpha | master
AMD Ryzen 7 2700X Eight-Core Processor | 16 Threads | 15.93 GiB RAM | TSC: 3.693GHz | AVX+ | FMA3
Goes Ingame, but very low FPS!
Used settings:
Interpreter (dynamic)
MFC Command
RSX FIFO Accuracy (Ordered & Atomic)
VBlank Frequency (3000Hz)
RE: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - yurinator557 - 05-05-2024
Need screenshots and a log to be able to move.
RE: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - theDreamcaster - 05-05-2024
(05-05-2024, 09:10 AM)yurinator557 Wrote: Need screenshots and a log to be able to move.
can't move anyway if change of vblank is required.
------------------
Using any of the following settings is not allowed for compatibility reports:
- CPU: SPU Block Size: Giga
- CPU: SPU XFloat Accuracy: Relaxed
- GPU: Shader Mode: Shader Interpreter only
- Advanced: Debug Console Mode: ON
- Advanced: Disable On-Disk Shader Cache: ON
- Advanced: VBlank Rate: Non 60Hz value
- Advanced: Clocks Scale: Non 100% value
- Any setting in the Debug tab
RE: Harry Potter and the Deathly Hallows: Part 2 [BLUS30768] - 1qazxcvbnmlp098 - 05-05-2024
I tested this game on default settings and it crashed even on a black screen, so you're right that I can't go to Ingame. I'm wondering if these games can be moved to Loadable because with the default settings I never managed to go even to the logo, but very often it hung on a black screen with the words "Compiling Shaders" written at the bottom left. In my opinion, this game should have the status Loadable .In my opinion, both of these parts should be moved to Loadable because with the default settings I only had a black screen