RPCS3 Forums

Full Version: RPCS3 doesn't continue compiling PPU modules after firmware installation
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hello everybody

Im going to go straight to the point:

When I try to install the PS3 firmware I get stuck at "Compiling PPU modules". I followed the quickstart guide but after I get the prompt that it successfully installed the firmware and LLE Modules it starts to compile PPU modules but stays at 0%. At least I think it starts as it doesn't even impact CPU performance. When searching for this problem in the forum I only find one thread of which I'm not sure if it's the same problem as the guy never mentions being stuck.

I attached the log files after cancelling the process.
Not sure if this matters but my PC specs:
Win 10
I5-4690k
gtx 1070
8GB RAM
Hello Dangel, that is weird, you try to do a fresh instalation of the emulator?